Use our new website
Order and more information for your region
Our distributors

Inteli AIN8

8 Analog Input Channels and 1 RPM/Impulse Input Module
Order code: I-AIN8
Ask for more info NOW

ComAp’s Inteli AIN8 module allows users to expand the amount of analog inputs for sensors and add Impulse/RPM input that can be attached to a controller. Up to 8 configurable inputs (sensors) can be attached to the controller, and up to ten (depending on the controller firmware) of the Inteli AIN8 modules can be connected to InteliSys NT, InteliGen NT, InteliMains NT controllers (up to four in case InteliDrive DCU controller).

Analog inputs:

Supported sensors:

  • Resistor 3-wire input
    • Common resistor: 0-250Ω, 0-2400Ω, 0-10kΩ
    • Temperature sensor: Pt100, Pt1000, Ni100, Ni1000
  • Current (active or passive sensors)
    • ±20mA , 0-20mA, 4-20mA
  • Voltage
    • ±1V, 0-2,4V, 0-5V, 0-10V
    • Lambda probes
    • Thermocouples are not supported (the measuring loop was designed for lambda probes, what caused non-support of thermocouples)

Impulse/RPM sensor:

  • RPM measuring pulses with frequency  4Hz – 10kHz
  • Impulse
    • Possibility to measure pulses from electrometer, flowmeter (measurement of total consumption, average fuel consumption)

The Inteli AIN8 is determinate for the InteliSys NT, InteliGen NT, InteliMains NT and InteliDrive DCU controllers. 



Find your local contact

All distributors

Our website uses cookies and similar technologies to provide you the best experience and to understand how you use our site.

You may either „Accept all“ by which you agree with using functional, analytical and marketing cookies. By pressing „Revoke“ only necessary cookies shall be allowed to enable the website and applications function correctly. To revoke your consent you can do it from footer menu in Change cookie preferences section.

Here or under the section Privacy you may find more detailed information on your privacy.